Wrapped and woven tiger’s eye stone, square copper wire and beads.

On assembly, couple parts proved a bit weak; might need to upgrade from pla

Handmade and hand-sewn manga-inspired custom zipper wallet with contrast stitching for a friend. I designed a stamp for the wallet in fusion and 3d printed it at the guild. The zipper tape and zipper pull are from a small etsy shop.

Finally got some time to update this project. Upgraded the limit switch to a hall effect sensor and replaced the plastic motor with a metal geared motors. New 3D printed parts for new components. Trying to get it ready for 3D Printopia!

Custom mount for an esp-32 camera module for Prusa i3 Mk3 type beds (new build MK4s have a different underbed structure). Mount can be rotated and pitched and locked in position. Camera module accessible via dovetailed friction fit access panel

Handmade magazine using illustration markers, color pencils and pens.

Tonight’s project was to do a practice run at a leather pouch wallet using some oil tanned scrap leather.

A vendor for gen con is going to be selling a plush with a magnet in its base. Had this idea so people could have it ride around on their shoulder.

Planning on growing some veggies this year, so I needed the room
Built these wondeful glorified rectangles for ~$12 for the wood, plus another $5-10 for the soil, each

Printed using Hatchbox Sparkle Green PLA

Not much to do at the car dealership while waiting for new brakes, but Lowes was less than a mile away! $40 build including the 3 dollar 8ft 2x4, saw, gloves, and nails for a butt joint

This one is the Crystal Dragon by Cinderwing3D.
You can find it on Myminifactory.